Electro-Voice Dx 38 Programmable Digital Sound System Processor

Electro-Voice EV Dx38 Programmable 24 Bit Digital Sound System Processor

30 user-configurable presets and up to 50 factory presets for a total of 80 selections

The Electro-Voice Dx 38 is a 1RU rackmount, programmable digital multi-speaker P.A. system processor and controller. The unit is equipped with 24-bit/48kHZ resolution A/D and D/A converters, 48-bit internal processing, and a versatile set of selectable, configurable EQ's, crossovers, delays, and compressor/limiters.

All audio connectors on the Dx 38 are electronically balanced XLR's, and a complement of MIDI In, Out and Thru jacks are included for external control and SysEx backup and software or preset updates.

Clean church pull, "only driven once a week by a little old lady :) , does exhibit cosmetic signs of use."

Specifications:
EV Dx38 Specifications
From the manufacturer:
  • Frequency Response   20 Hz - 20 kHz, -0.5dB
  • Dynamic Range     115dB
  • Input Connections     2 x XLR Female, Balanced
    1 x MIDI In
  • Output Connections     4 x XLR Male, Balanced
       2 x XLR Male, Direct Out
       1 x MIDI Out
       1 x MIDI Thru
  • Input Impedance     20 kOhms
  • Output Impedance     <100 ohms="">
  • Maximum Input Level     +30dBu
  • Maximum Output Level     +21dBu
  • Sample Rate     48kHz
  • RTA Mic Phantom Voltage     No
  • Crosstalk (Main Outputs)     Not Specified by Manufacturer
  • THD & Noise   
    <0.05% (with="" optional="" transformer)="">
       <0.01% (without="" transformer)="">
  • Dimensions     19 x 1.7 x 14.7" (483 x 43.6 x 374mm)
  • Weight 11 lb (5 kg)
  • Switchable infrasonic filter and ground-lift

IMPORTANT NOTE: System is as acquired and is "Locked". This is a feature, not a problem. The locking function provides protection against inadvertent operation via function-lock, but without the programmable code, the unit will not enter service mode via the front panel. A brief search by us found it can be done via RS232 terminal as follows: 1. Connect DX38 to PC via RS232. 2. Use EV RACE software to backup your user presets (they will be deleted during the reset) 3. Close RACE 4. Open a normal terminal emulator and connect to serial port at 19200bps 5. Type following command and press enter: /SERVICE/START EEPCLR The EEPROM will be cleared and you will hear unit click / reset, and then the lock code will be reset to default and service mode will be available from front panel interface.
If you have problems in terminal type ? and press enter for basic help.

CHECK ALL SHIPPING OPTIONS FOR LOWEST COST OR BEST OPTION
Grab this GREAT ITEM now before someone else does

Please refer to all photos as they are part of the description and stated condition.
Sale is for described item only. Props seen in photos are not included. If uncertain, please ask before ordering.

335425932061
1 Item
Used
Pulled from a working environment (a local Church), power tested, and powers on as it should. No further testing has been performed on this device. It requires a standard three prong power cord, which will be included. Some scuff marks and expected cosmetic signs of use on top.

Data sheet

Model
Dx38
Type
Digital Sound Processor
Form Factor
Rack Mountable
Input/Output Ports
XLR In
XLR Out
Number of Channels
6
Analog/Digital
Digital

You might also like

2 other products in the same category: